impregnation

A simple nonlinear control method to design the missile autopilot: (system) immersion and (manifold) invariance is presented.

为了克服非最小相位特性造成的设计控制器的困难,介绍了一种新颖的导弹非线性控制算法——(系统)浸入和(流行)不变算法,将导弹的输出跟踪问题转化为系统的镇定问题。

Let X:M n→E N be a smooth immersion of Riemannian manifold (M n,g) into euclidean N-space, and <h> and H the length of the second fundamental form and mean curvature of the immersion X respectively.

设Ｘ：Ｍｎ →ＥＮ 为黎曼流形（Ｍｎ ，ｇ）到欧氏Ｎ—空间的等距浸入，＜ ｈ ＞ 及Ｈ 分别表示浸入Ｘ 的第二基本形式的长度及平均曲率，本文将证明积分∫Ｍ ｎ ＜ ｈ ＞ ｎｄｖ 在保高斯映射的共形形变下是不变量。

Improvement on Leakage of Axial Sealing of Steam Turbine

B6-3.43/0.981型背压汽轮机轴封漏汽的治理

INSPECTION FOR REAR SEAL AREA LEAKS

后密封区的泄漏检查

It can prevent air leakage and oil leakage efficiently.

能有效的起到密封，防止漏油、漏气作用。

If the leakage occurs at the rear oil seal area, refer to the section, Inspection for Rear Seal Area Leak.

如果泄漏发生在后机油密封区，参看“后机油密封区泄漏的检查”一节。

The primary function of sealing gasket is to prevent gas from leakage.

密封垫圈的主要作用是防止气体泄漏。

Note: Squeezing an unsealed cartridge will release ink.

注意: 挤压没有封住的墨盒会漏墨。

Leakage is the trickiest problem in sealing system.

漏！是密封系统中最为头痛的问题。

Sealed radioactive sources--Leakage test methods

GB15849-1995密封放射源的泄漏检验方法

Seat ring is seal welded to eliminate leak path.

阀座环通过密封焊接，消除泄漏通道。

Radiation protection - Sealed radioactive sources Leakage test methods???

辐射防护－－密封放射源泄漏检验方法

This check does not simulate a seal leakage.

这个测试并不等同于密封泄漏。

The seal has worn and the machine is losing oil.

密封处已经磨损，机器漏油了。

Research of Helium Mass Spectrometer Leak Detection Technology on Sealed Adaptation of the Optical Fiber

光纤密封转接的氦质谱检漏技术研究

Analysis of Dynamic Performance and Leakage for Finger Seal

指尖密封动态性能分析与泄漏量计算

The Treatment for Concrete Leakage on the Stop Ends of the Post-Tensioning Beam on Shenshuo Railway

神朔铁路后张梁封端混凝土渗漏治理

Analysis and Improvement of Leaking Cause for GA5201 Mechanical Seal

GA5201机械密封泄漏原因分析及改造

Hijack Linux System Call Force Out Core Dump Hole Attack

劫持Linux系统调用封杀Core Dump漏洞攻击

A material used to prevent leakage or seepage, as around a pipe joint.

密封圈用来防止漏水或渗漏的一种材料，如水管的接合处