Outside Wall Heat Insulation Unitization Technology of TS Site Template Pouring of Foaming Polyurethane;
TS现场模板浇注发泡聚氨酯外保温成套技术
A mold for the setting of concrete.
模板浇注混凝土的模板
Optimization Design of Injection Mold Gate for the Faceplate Set Based on MoldFlow Software
基于MoldFlow的面板注射模浇口的优化设计
The Gating Design for Negative Pressure EPC.
负压消失模铸造原料磨衬板的浇注工艺设计
The influence of cast mold in rebound testing of concrete compressive strensth
浇注模板对回弹法检测混凝土抗压强度的影响
The plexiglass product usually may divide into pours the board, squeezes out the board and the mold plastic.
有机玻璃产品通常可以分为浇注板、挤出板和模塑料。
Analysis for pressure cast model and secondary cooling water dynamical model of continuous slab caster in Bao Steel
宝钢板坯连铸机压缩浇注模型及二冷水动态模型剖析
Design of Auto-Sheared Injection Mold for Edge Gate of FPD Cabinets
自动切除平板电视面框侧浇口废料的注射模设计
The concrete pump is only relocated after a number of sections have been completed.
浇注完数段路面板后,才移动混凝土泵。
Discussion of Plan for Massive Concrete Placing of Pump Gate Floor
泵闸底板大体积混凝土浇注方案讨论
"After each 10 m long Base part-section is concreted, the TVM 18 is relocated, after each roadway surface concreting cycle, the pipe Bridge is moved."
"每浇注10米基底,就移动TVM18, 浇注完一块路面板后,移动管道桥。"
The Secondary Development of Autocad for Feed System of Injection Mold;
注塑模浇注系统的AutoCAD二次开发
Design of Injection Mold Gating System of the Plastic Gear Based on MoldFlow Software
基于MoldFlow塑料齿轮注射模浇注系统设计
The Design and CAE Analysis in Multy-carities Injection Moding Feed System
多型腔注塑模浇注系统设计及CAE分析
The unset concrete is simply poured between formwork to the required thickness of the wall, as shown in Fig.3.
如图3所示,只需将搅拌好的混凝土浇注到模板中,达到墙体所需要的厚度即可。
THE TECHNOLOGY OF ASSEMBLED FIELD-CAST CONCRETE WALL WITHOUT DEMOULDING
拼装式现浇混凝土墙体免拆模板技术
NEWLY CAST-IN-SITU CONCRETE SHWALL NETTED FORMWORK TECHNIQUE
新型现浇混凝土剪力墙网状模板技术
Adeline steelmaking process
阿德莱熔模铝热离心浇注法
starch dropped goods
用淀粉模型浇注成形的糖果
